Jacuzzi SWIMSPA Power Pro J19

27
 Lock Icon: When displayed, indicates the panel is in a locked mode. To unlock or lock a
seng or panel lock, first press the corresponding icon on the Lock Screen, then press
and hold the word “Lock” for 5+ seconds unl the text and icon change to the opposite
state.
There are 2 lock icons that can be shown on the tle bar of most screens. A tall skinny one
represenng a sengs lock is applied. It is shown on screens that are affected by the sengs
lock. And the standard lock icon Padlock which represents the panel being locked. If both
sengs and panel are locked, only the panel lock will show since the sengs lock doesn’t do
much in that situaon. When the panel is locked, the Sengs Screen will only show items not
affected by that lock (System Info and Lock Screens)
 Adjust set temperature higher
 Adjust set temperature lower
 Message waing indicator: The Message Waing Indicator will show on of the following
icons
= fatal error (swim spa can’t funcon unl it is fixed)
= Normal Error or Warning
= Reminder Message
= Informaon Message
= Spa equipment icon
Brings up a screen where the spa jets, blower or other equipment can be controlled. While on the Spa
Equipment Screen, you can press a Jets buon once for low speed, and if configured press it again for
high speed.
= Jet is inacve. Indicates if a pump is running or not.
= Sengs is acve
= Sengs is inacve
= Different animaon sequences, including blinking, may indicate different stages of heang.