Bar Code Scanner (USB)
Installation Instructions
Follow these instructions to connect and program any of these USB bar code scanners:
• JADAK flexpoint HS
-1M on the X-Porte, Edge, M-Turbo, S Series, or NanoMaxx ultrasound system
• Sy
mbol LS2208 on the NanoMaxx, M-Turbo, or S Series ultrasound system
When connected, the bar code scanner is listed on the system’s USB or USB Devices setup page.
See the Bar Code S
canner User Guide from FUJIFILM SonoSite for information on safety and cleaning.
Configuring the JADAK bar code scanner
To connect and program the Jadak bar code scanner
1 Attach the scanner cord to the bar code scanner and to a USB port on the ultrasound system.
See JA
DAK flexpoint HS-1
M
Quick Start Guide included with the bar code scanner.
For location of USB ports, see the ultrasound system user guide or Help (X-Porte only).
2 T
urn on the ultrasound system.
3 S
can the following two bar codes in the order listed:
USB Kybrd
STX Prefix
ETX Suffix
DOS CTRL
ASCII MODE
4 To ensure the scanner has been configured to work with your ultrasound system, FUJIFILM SonoSite
recommends opening a patient information form on your system and scanning a bar code. Your system is
successfully configured when you scan a bar code and the patient ID (and associated patient information, if
any) populates the patient information form.
Configuring the Symbol bar code scanner
To connect and program the Symbol bar code scanner
1 Attach the scanner cord to the bar code scanner and to a USB port on the ultrasound system.
See S
ymbol LS2208 Quick Start Guide included with the bar code scanner.
For location of USB ports, see the ultrasound system user guide.
To Next Page
Need help?
General
