Jaga JRT-200 - Page 2

25 juni 2018, 8:45 - Jaga N.V.
Jaga Room Thermostat JRT-200 installation
Installation
WIRING: Warning: The installation of the thermostat should be performed by qualified personnel and must comply with the applicable
local and national electrical codes and utility requirements. All wire connections must be tightened and properly arranged to prevent
a shortcircuit. Turn off the power at the electrical panel to prevent electrical shock or product damage.
24V AC/DC
M
1234567891011
24V AC/DC
M
1234567891011
24V AC/DC
M
1234567891011
To remove the wall plate, use a Phillips
screwdriver to loosen the two screws from
the bottom of the wall plate
Remove the front panel When not using a recessed conduit box:
• mark out and drill the holes
• screw the device to the wall.
The type of wall, solid or cavity, determines
the type of screw or plug that is used.
24V AC/DC
M
1234567891011
24V AC/DC
M
1234567891011
24V AC/DC
M
1234567891011
• flush wiring can enter from the rear
through the aperture in the wall plate
• connect the JRT-200 according the wiring
diagrams** on this page
Reassemble the front panel Tighten the screws with a Phillips screwdriv-
er. (Do not over-tighten.)
Warning: Turn off the power at the electrical panel to prevent electrical shock or product damage.
** Wiring diagram
2-Pipe 4-Pipe
1234567891011
1234567891011
H/C VALVE
0...10V COM
0...10V COM
KEY CARD
-
+
L
N
24V / 220VAC
DC 24V
DC 24V
C VALVE
H VALVE
KEY CARD
-
+
+
+
-
-
L
N
24V / 220VAC
1234567891011
1234567891011
H/C VALVE
0...10V COM
0...10V COM
KEY CARD
-
+
L
N
24V / 220VAC
DC 24V
DC 24V
C VALVE
H VALVE
KEY CARD
-
+
+
+
-
-
L
N
24V / 220VAC
H/C Heating / Cooling C Cooling
H Heating GND N