RAC Plus User’s Manual
4-6
Menu 4 - Clock Set
The RAC Plus will compute & display time as either elapsed time from
when the instrument was powered up, or real time if the timer has been set.
The timer starts automatically at zero when the RAC is powered-up. Time
is displayed in D-1 as hh.mm.ss.
To View Elapsed Time:
Press the Menu key, then the #4 key,
then the Enter key. D-1 shows the
elapsed time since the RAC was pow-
ered on. At this time you can stop and
reset the timer with the CLR (clear)
key or just let it continue to run. To
return to normal mode, press the Menu key then the Enter key.
To Set Timer to Real-Time:
Step 1
Press the Menu key, then the #4 key, then the Enter key. D-1 shows the
elapsed time since the RAC was powered on, as shown in Figure 4.6
above.
Step 2
Press the Clear key. Using the number
keys, key in the time you wish to dis-
play (hh.mm.ss format). This can be
either 12 or 24 hour format (i.e 1 PM
= 13 hrs).
Step 3
Wait until the keyed in time is reached
and press the Enter key to begin the
clock counting.
Step 4
To return to normal mode, press the
Menu key then the Enter key.
Fig. 4.5 — Elapsed Time
Fig. 4.6 — Clock Time Entered
Fig. 4.7
Counting from Entered Time
To Next Page
Loading...
