Fridgewatch 2000 Controller Mk5
Publication 3-59 Section 3
Page 3 of 222 Issue 3.2 : 05.23
Safety
In common with most other forms of mechanical and electrical
equipment, there are a number of potential hazards associated with
operating and servicing refrigeration plant.
In writing this instruction manual, every emphasis has been given to safe
methods of working.
These safety instructions are intended to draw attention to the potential
hazards that could be encountered during installing, operating and
maintaining the plant.
At the same time, it should be emphasised that these notes are not
exhaustive, and are principally intended to draw attention to the most
important points; where necessary, reference is made to other parts of
the manual.
NOTE: The installer is responsible for the correct
installation of equipment, and on completion, the owner
and/or user are responsible for safe operation and
maintenance.
Contents Personnel Permitted to Install, Commission and Maintain the Plant
It is essential that only authorised and competent personnel are allowed
to install, commission and maintain the Fridgewatch Controller.
A permit to work system should be introduced before commissioning
begins, and should be rigorously enforced thereafter.
Any person rendering assistance or under training must be supervised by
the authorised competent person who has responsibility for safety.
Personnel must be familiar with the plant’s construction, operation and
the hazards involved.
All personnel should make a thorough study of these instructions before
undertaking installation, commissioning, maintenance or repair
procedures.
To Next Page
Loading...
Need help?
General
