Jands ESP II 24 User Manual

11
Using Channel Flash Buttons
Channel Flash Buttons
These buttons correspond to the Channel faders and perform two func-
tions:
1 Flash. The buttons are used to momentarily flash on a channel. The
type of operation (add, solo, latch) of the flash button depends on the
setting of the Add / Solo master switch
2 Inhibit. To prevent a channel from appearing in any output, hold the
Flash button down and press the DBO button. Repeat this procedure
to cancel inhibit.

Jands ESP II 24 Specifications

General

Brand	Jands
Model	ESP II 24
Category	Controller
Language	English