Jandy Pro JEP-R User Manual

H0412200 Rev J
ENGLISH
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and
qualified in pool equipment by the jurisdiction in which the product will be installed where such state
or local requirements exist. The maintainer must be a professional with sufficient experience in pool
equipment installation and maintenance so that all of the instructions in this manual can be followed
exactly. Before installing this product, read and follow all warning notices and instructions that accompany
this product. Failure to follow warning notices and instructions may result in property damage, personal
injury, or death. Improper installation and/or operation will void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which can
cause serious injury, property damage, or death.
ATTENTION INSTALLER - This manual contains important information about the
installation, operation and safe use of this product. This information should be given to
the owner/operator of this equipment.
INSTALLATION AND
OPERATION MANUAL
Jandy Pro Series
JEP-R
Variable-Speed Pump Digital Controller
For use with Jandy Pro Series Variable-Speed Pumps
For Indoor or Outdoor Installations

Jandy Pro JEP-R Specifications

General

Brand	Jandy
Model	Pro JEP-R
Category	Controller
Language	English

Summary

Section 1. IMPORTANT SAFETY INSTRUCTIONS

1.1 General Safety Instructions and Warnings

Covers general safety, including suction entrapment, child use, valve operation, suction fittings, and hyperthermia risks.

Electrical and System Installation Safety

Addresses risks from piping system tests, electrical codes, GFCI protection, and improper installation.

Spa Usage and Health Safety Precautions

Details safety for spa users, including health conditions, water temperature, and appliance proximity.

1.2 Pool Pump Suction Entrapment Guidelines

Provides detailed guidelines on preventing suction entrapment hazards for pool pumps.

Section 2. Installation of the Digital Controller

Introduction and Controller Panel Overview

Additional Materials and Backplate Installation

Pump Connection and Switch Settings

Covers wiring the controller to the variable-speed pump and setting the pump's dip switches.

Remote Contact Connection and Operation

Details connecting remote controls for speed selection and initial operation.

Section 3. User Operation of the Variable-Speed Controller

Manual Pump Start, Stop, and Speed Adjustment

Timeclock Setup and Operation

Guides users on setting up and utilizing timed pump programs.

Section 4. Service Setup Options

Entering and Navigating Service Setup

Pump Speed Limits and Factory Defaults

Fault History and Priming Configuration

eStar Speed, Freeze Protect, and Pump Type