Janome 1600P series - Bobbin Handling and Threading; Removing Bobbin Case and Bobbin; Setting the Spool of Thread

7
To Remove Bobbin Case and Bobbin
q Hook cover plate
w Hook cover
e Latch
r Bobbin case
t Bobbin
z Raise the needle and presser foot.
Remove the hook cover plate q and open the
hook cover w.
x Pull open the latch e of the bobbin case r. Take
the bobbin case straight out of the hook.
• To remove the bobbin from the bobbin case:
Release the latch, then drop the bobbin t out of
the bobbin case as illustrated.
* Only use this exclusive bobbin for model 1600P.
CAUTION
Turn the power switch off and unplug the sewing
machine from the electrical outlet
t
Setting the Spool of Thread
q Spool of thread
w Spool pin
e Spool cap
• Setting a spool of thread:
Place a spool of thread q on the spool pin w
with the thread coming off the spool as shown.
Attach the spool cap e, and press it firmly against
the spool of thread.
r Spool holder
t Net
• Setting the thread cone:
Place the spool holder r on the spool pin, then
place the thread cone on the spool holder.
Cover the thread cone with the net t if the spool
thread is shaky when sewing.
e
q
w
r
t
q
w
z
r
r
x
e