Why is the bobbin thread breaking on my Janome MOD-100?
The bobbin thread may break because: * The bobbin thread is not threaded properly in the bobbin holder. * Lint has collected in the bobbin holder. * The bobbin is damaged and does not turn smoothly, so change the bobbin. * The thread is wound loosely on the bobbin.
Why is my Janome Sewing Machine so noisy?
Your Janome Sewing Machine might be noisy because thread has been caught in the hook race, or lint has built up in the hook race or bobbin holder.
Why is my Janome Sewing Machine not working?
Your Janome Sewing Machine may not work if it is not plugged in, thread has been caught in the hook race, or the bobbin winder spindle is not returned to the left after bobbin winding.
How to prevent seam puckering on my Janome MOD-100?
Seam puckering may occur on your Janome Sewing Machine if: * The needle thread tension is too tight. * The needle thread is not threaded properly. * The needle is too heavy for the fabric being sewn. * The stitch length is too long for the fabric; make the stitch shorter. * A stabilizer is not used when sewing very fine fabrics; apply a stabilizer.
Why is the fabric not feeding smoothly through my Janome Sewing Machine?
The fabric may not feed smoothly in your Janome Sewing Machine if the feed dog is packed with lint, the stitches are too fine (make the stitch longer), or the feed dog is not raised after “drop feed” sewing.
Why is buttonhole sewing not working properly on my Janome Sewing Machine?
If buttonholes are not sewing properly on your Janome Sewing Machine, it may be because the stitch density is not suitable for the fabric, interfacing has not been used for stretch or synthetic fabric (apply an interfacing), or the buttonhole lever is not lowered.
Why does the needle thread keep breaking on my Janome MOD-100?
The needle thread may break due to several reasons: * The needle thread is not threaded properly. * The needle thread tension is too tight. * The needle is bent or blunt. * The needle is incorrectly inserted. * The needle and bobbin threads are not set under the presser foot when starting to sew. * The thread is either too heavy or too fine for the needle.
What causes loops on the seams when using my Janome Sewing Machine?
Loops on the seams of your Janome Sewing Machine can be caused by the needle thread tension being too loose, or the needle being too thick or too fine for the fabric.
Connect the power supply to the machine and outlet.
Details on start/stop, reverse, auto-lock, and speed control.
Explanation of mode and value set keys for adjustments.
Guide to choosing stitch patterns via the LCD.
Instructions for removing and attaching presser feet.
Recommendations for needle and thread types based on fabric.
How to perform basic straight stitch sewing.
Guidance on the triple stretch stitch for durable seams.
Adjusting the width of the zigzag stitch.
Adjusting the length of the zigzag stitch.
Method for attaching elastic using a specific stitch.
How to sew a standard square buttonhole.
Sewing round-end buttonholes on fine fabrics.
Initial steps to begin darning.
How to attach the special zipper foot.
Adjusting stitch patterns for correct appearance.
How to clean essential internal components.
General| Brand | Janome |
|---|---|
| Model | MOD-100 |
| Category | Sewing Machine |
| Language | English |
To Next Page
