EasyManuals Logo

Janome MOD-100 User Manual

Janome MOD-100
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
38
Adjusting the shape of an eyelet
Correct the shape of the eyelet as follows:
Press the mode key q until the cursor w appears under
the stitch length value (“L3” is the default setting value).
If the eyelet gap overlaps, press the “+” sign on the value
set key to make the darn even.
If the eyelet gap opens, press the “” sign on the value
set key to make the darn even.
q Mode key
w Cursor
e Value set key
NOTE:
The shape can be adjusted within L1 to L5.
Eyelet
q Stitch pattern: 27
w Thread tension dial: 1 to 4
e Presser foot: Satin stitch foot F
The eyelet is used for belt holes etc.
Starting to sew
Lower the needle at the starting point and lower the
presser foot. Start the machine.
The machine will stop automatically when completed.
q Starting point
Open the eyelet with an awl, eyelet punch or pointed
scissors (an awl, eyelet punch or pointed scissors are not
provided with the machine).
q
w
e
4
q
w
e
q

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Janome MOD-100 and is the answer not in the manual?

Janome MOD-100 Specifications

General IconGeneral
BrandJanome
ModelMOD-100
CategorySewing Machine
LanguageEnglish

Related product manuals