Janome 444 - Page 3

er —————————————————
ADJUSTING HEIGHT OF NEEDLE BAR
Skipped stitches are often caused by incorrect height
of needle bar. Adjust the height as follows:
1. Set zigzag width regulator lever (#576009) at 0.
2. Turn hand wheel towards you until tip of shuttle hook (#32096)
touches left side of needle.
3. Loosen needle bar connecting stud screw (#042).
4, Distance between upper edge of needle hole and tip of shuttle
hook should be 3/32 in. + 1/64 in.. To adjust this, move needle
‘ bar (#38032) up and down,
5. Tighten needle bar connecting stud screw firmly,
Sa, =