EasyManua.ls Logo

Janome AirThread 2000D Professional - Adjusting Chaining Finger Position; Set Chaining Finger to S; Adjust Chaining Finger Plate

Janome AirThread 2000D Professional
112 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
58
Adjusting Chaining Finger Position
Set the chaining finger lever to “S” position. If an adjustment is
needed, loosen the two 1.5mm hexagon screws. Move the chaining
finger set plate as needed. Tighten the 2 screws.

Table of Contents

Related product manuals