25
12340
When finished, push the buttonhole lever up
as far as it will go.
¥To adjust buttonhole stitch density.
Set the stitch length slider between 0.5 and 1.0 to
adjust the buttonhole stitch density.
If the stitch density on the left and right side of the
buttonhole are unbalanced, remove the accessory
box and adjust the pitch balance dial.
If the left side is denser than right side,
turn the adjusting dial in the Ò + Ó direction.
If the left side is less dense than the right side,
turn the adjusting dial in the Ò Ð Ó direction.
To Next Page
Loading...
