JANOME Embroidery Software Instruction Book
Chapter 27 Design Gallery Basics
228
To reconnect Design Gallery with EasyDesign
1 Check that your dongle security device is connected.
2 Open Design Gallery and check that it runs correctly
on its own – close Design Gallery, then open
EasyDesign by clicking its icon on the Windows
Desktop.
3 If none of the above correct the problem, re-install
EasyDesign.
4 Check that the version of EasyDesign you are running
is the same as that registered in Design Gallery
Shortcut Properties:
Right-click the Design Gallery icon on your Windows
Desktop, then select Properties.
The Design Gallery Properties dialog opens.
Click the Shortcut tab, and read the last text in the
Target field – e.g. version0.1D.
This version should be identical to the version of
EasyDesign you are running. If it is not, change it to
the correct version and click OK.
5 Install EasyDesign again.
shortcut
To Next Page
Loading...