JANOME Embroidery Software Instruction Book
Appendix B Supported Files and Hoops
250
Supported electronic artwork
formats
Artwork can be imported into JANOME Embroidery
Software in both vector and bitmap formats.
Generally speaking, vector images preserve the
picture quality when resized, whereas bitmap
images cause problems of pixilation and image
degradation when enlarged or scaled down.
However, any scaling required should be done
before importing into EasyDesign as the importing
operation automatically transforms vector images
into bitmaps. See Digitizing with Backdrops for
details.
Supported vector formats
JANOME Embroidery Software supports the
following vector formats:
Supported bitmap formats
JANOME Embroidery Software supports the
following bitmap formats:
Supported hoop types
JANOME Embroidery Software supports a variety of
hoop types used with the different machine
models. See also Selecting machine models.
The Hoop Type list is automatically filtered
according to the current machine type. Only those
hoops supported by the current machine are
available. See Grids and Hoops for details.
Note If you attempt to save a design in a hoop
size not supported by the machine, JANOME
Embroidery Software will prompt you to select a
different hoop. If you attempt to send a design to
machine with a hoop not supported by the
machine, you will be prompted to select a different
hoop. See also Saving designs for machine.
10O Toyota z†
Extension Format Read Write
EMF Enhanced Metafile z
EPS Encapsulated PostScript z
WMF Windows Metafile z
Extension Format Read Write
BMP Windows Bitmap zz
JPG JPEG File Interchange zz
PCX ZSoft zz
PNG Portable Network Graphics z
Extension Format Read Write
† JANOME Digitizer MB only
To Next Page
Loading...