Janome MC8900 QCP - Stretch Stitch Feed Balance

32
(A)
(B)
33 –
39 mm
(A)
(B)
Stretch stitch
balance dial (C)
Setting mark (D)
Base lid (E)
Adjusting screw (F)
MECHANICAL ADJUSTMENT
Stretch stitch feed balance
Adjust the stretch stitch balance dial C at the setting mark D.
The measurement of five of test patterns should be in the range of 33 to 39 mm as shown.
To adjust:
1. While pressing the needle up/down and lock stitch
buttons, turn the power switch on.
The LCD screen display "Factory adjust", then
adjusting screen will appear.
Turn the jog dial to select "08.88888888".
Press the confirm button (Enter key).
2. Set the stretch stitch balance dial C at the setting
mark D.
3. Sew test patterns and check the measurement of five
of them.
The range of patterns should be in the range of 33 to
39.
4. If not, remove the base lid E.
Press the right arrow of button.
The adjusting screw F comes to the adjusting position.
 • TurntheadjustingacrewinthedirectionofAifthe 
measurement is more than 39 mm.
 • TurntheadjustingscrewinthedirectionofBifthe 
measurement is less than 33 mm.
5. Press the right arrow of button and sew test
patterns.
Check the measurement of five of them.
6. Turn off the power switch.
7. Attach the base lid E.