Need help?Do you have a question about the Janome MC350E and is the answer not in the manual?
General| Brand | Janome |
|---|---|
| Model | MC350E |
| Category | Sewing Machine |
| Language | English |
Procedure to remove and attach the face cover.
Procedure to remove and attach the belt cover.
Procedure to remove and attach the base cover.
Procedures to replace the bed cover and base lid.
Procedure to remove and attach the base unit.
Procedure to remove and attach the front cover.
Procedure to remove and attach the rear cover.
Steps to position the needle correctly in the needle plate hole.
Procedure to set the correct timing between needle and hook.
Method to adjust needle bar height for optimal hook race engagement.
Steps to set the correct clearance between needle and rotary hook.
Procedure to adjust gear backlash for smooth operation.
Procedure to set the correct needle stop height.
Method to adjust upper thread tension for optimal stitch quality.
Steps to adjust the tension release mechanism for correct operation.
Procedure for replacing the thread tension unit.
Procedure for replacing a damaged threader plate hook.
Steps to adjust the threader plate alignment with needle eyes.
Procedure to set the correct height of the embroidery foot.
Diagram showing connector assignments on the main circuit board.
Procedure to remove and install the main circuit board.
Steps to remove and install the touch panel.
Procedures for replacing circuit boards F and F2.
Method to adjust the solenoid for proper function.
Procedures for replacing the DC motor and adjusting belt tension.
Steps to remove and install the carriage plate unit.
Procedure for precise adjustment of X and Y sensors.
Simplified procedure for adjusting X and Y sensors without base removal.
Steps to adjust carriage motor gears to reduce noise.
Procedure to remove and install the switching power supply.
To Next Page
