8
MC350E
A
B
C
D
Adjusting Needle Drop Position
1. Lower the needle to its lowest position by turning the
handwheel.
2. Remove the face cover and loosen Screw ,
move the Needle bar supporter to the right or
left until the needle comes to the center of the
Needle plate hole .
3. Tighten the Screw .
4. Attach the face cover.
Screw
Needle bar supporter
Needle
Nedle plate hole
The needle should be positioned at the center of the needle plate hole.
A
B
C
D
A
B
A
C
D
To Next Page
Loading...
