Janome MC350E - Adjusting Thread Tension

14
MC350E
(A)
(B)
Adjusting Thread Tension
The standard upper thread tension should be 51 to 59 grams when the tension dial
is set at “3”, measured with a #50 polyester thread being pulled at approximately 110
mm/sec. in the direction of arrow.
1. Set the tension dial at " 3 ".
2. Lower the presser foot.
3. Remove the front cover unit (See P. 6).
3. If the thread tension is more than 59g, turn the lead screw
in the direction (A).
4. If the thread tension is less than 51g, turn the lead screw
in the direction (B).
(C) Pulling direction: (Pulling speed 110 mm/ Sec.)
Polyester sewing thread #50
(White)
(C)