Need help?Do you have a question about the Janome MC6300P and is the answer not in the manual?
General| Brand | Janome |
|---|---|
| Model | MC6300P |
| Category | Sewing Machine |
| Language | English |
Instructions for removing and attaching the face plate.
Instructions for removing and attaching the top cover.
Steps to remove and attach the belt cover.
Steps to remove and attach the machine base.
Procedure for replacing the fuse on circuit board A.
Steps to remove circuit board F from the machine.
Steps to remove the speed control lever.
First method to adjust clearance between needle and rotary hook.
Second method to adjust clearance between needle and rotary hook.
Adjusting the feed dog to be parallel with the needle plate.
Adjusting the position of the threader plate if misaligned.
Procedure to check the auto-thread cutter after installation.
Setting the correct angular position of the upper shaft declutch device.
Reducing play in the declutch piece for smooth operation.
Procedure for checking and adjusting motor belt tension.
Steps to activate the diagnosis device and start checking.
Checking buzzer, LED signals, and sewing light for correct function.
Testing function buttons on the front cover for correct LED output.
Testing various switches like bobbin winder, presser bar lifter, etc.
Testing photo sensors for buttonhole, auto thread cutter, feed, and zigzag.
Checking the velocity sensor reading for correct operation.
Testing the speed control slider and its LED display.
Testing the foot control pedal and its LED display.
Testing solenoids for auto thread cutter, bobbin idling, and upper shaft declutch.
Checking stepping motors for needle bar, tension, and feed dog.
Testing the driving and bobbin winding motors.
To Next Page
