Janome MC6300P - AUTO THREAD CUTTER SOLENOID ADJUSTMENT

39
Yoke (A)
Plunger (B)
2.5 mm (C)
Setting plate (E)
Setscrews (D)
1. Remove the machine base (refer to page 2).
2. Loosen the 2 setscrews (D) and adjust the distance
to 2.5 mm (C) by moving the setting plate (E).
3. Tighten the 2 setscrews (D).
4. Attach the machine base.
TO ADJUST POSITION OF SOLENOID FOR AUTO THREAD CUTTER
The distance between the yoke (A) and the snap ring on the plunger (B) should be 2.5mm.