Janome MC6300P - LOWER SHAFT PARTS SETTING POSITIONS

30
SETTING POSITIONS OF PARTS ON LOWER SHAFT
The setting positions of the parts on the lower shaft are as shown below.
The setting angle of the parts (A), (B) and (C) is the same as (D).
Belt wheel
Spring pin (D)
Shield plate
Feed cam (C)
Cam (B)
Lower shaft
gear
Pin
Feed lifting cam
Cam (A)
X
X view
Y
Belt wheel
setting
mark
Belt wheel
setting
mark
Spring pin (D)
Spring pin (D)
Pin
Y view