4
Setscrew (A)
Setscrew (C)
Setscrew (B)
Setscrew (D)
Front cover
[View from belt
cover side]
Insulation paper
Cords
Setscrew (B)
Circuit board A
[ To remove ]:
1. Remove the face plate, top cover and belt cover
(refer to pages 1 and 2).
2. Loosen the setscrews (A), (B), (C) and (D).
3. Pull out the connectors (refer to page 10) and
remove the front cover.
[ To attach ]:
4. Proceed with the above procedure in reverse.
When attaching the front cover, ensure that the
cords shown in the photo on the left do not get
caught between the cover and the parts.
TO REMOVE FRONT COVER
To Next Page
Loading...
