32
Pressure = 200g
(B)
Deflection =
5mm (C)
Setscrew (A)
[To remove]:
1. Remove the front cover (refer to page 4).
2. Remove the motor belt.
3. Pull out the connector from the circuit board A.
4. Remove the 2 setscrews (A) and pull out the
driving motor.
[To attach]:
5. Tighten the 2 setscrews (A) slightly.
6. djust the belt tension and tighten the 2 etscrews
(A) firmly.
[Correct motor belt tension]:
When the middle of the motor belt is pushed with a
pressure of 200g (B), the deflection should be 5
mm (C).
TO REPLACE DRIVING MOTOR
To Next Page
Loading...
