Janome MC6300P - NEEDLE THREADER PLATE REPLACEMENT; THREADER PLATE POSITION ADJUSTMENT

23
Setscrew (D)
(X)
(X) view
Hexagonal
socket screw (F)
Threader plate (C)
Setting plate (G)
(Fig. I)
(Fig. III)
Threader plate unit (A)
Pin (B)
Needle
bar
[ To remove ]:
1. Remove the foot holder.
2. Pull out the threader plate unit (A).
[ To attach ]:
3. Push the threader plate unit (A) up to snap it with
the pin (B) as shown in Fig. I.
4. Attach the foot holder.
To adjust the position of the threader plate (C) If
the threader plate is slightly out of alignment,
loosen the setscrew (D) and adjust the position as
shown in Fig. II.
TO REPLACE NEEDLE THREADER PLATE
(Fig. II)