26
1. Set the needle bar at the lowest position.
Insert the pin (B) into the groove of the cam (A)
by pushing down the driving arm (1).
In this state, turn the hand wheel to set the
sliding plate (D) at the rightmost position.
2. Loosen the setscrew (C) and turn the cam (A)
to set the the left end of the sliding plate (D) is
in line with the right side of the second feed dog
from the right.
Tighten the setscrew (C).
Sliding plate (D)
Cam (A)
Setscrew (C)
Left end of the sliding plate is in
line with the right side of the
second feed dog.
Sliding plate (D)
TO ADJUST POSITION OF SLIDING PLATE
Pin (B)
To Next Page
Loading...
