Janome MC6300P - CIRCUIT BOARD F AND SPEED CONTROL LEVER REPLACEMENT; CIRCUIT BOARD F REPLACEMENT; SPEED CONTROL LEVER REPLACEMENT

9
TO REPLACE CIRCUIT BOARD F AND SPEED CONTROL LEVER
Circuit board F
CS ring (E)
Speed control lever (C)
Setscrew (A)
CS ring (E)
Connector
(B)
[To remove the circuit board F]
1. Remove the front cover (refer to page 4).
2. Pull out the connector from the circuit board A.
(refer to page 7).
3. Remove the 3 setscrews (A) and 2 CS rings (D).
[To attach]
Reverse the above procedure.
Make sure that the buttons are placed in the
correct places and direction.
[To remove the speed control lever]
1. Remove the front cover (refer to page 4).
2. Pull out the connector (B) from the circuit board
K.
3. Remove the 2 CS rings (E), and remove the
speed control lever (C).
[To attach]
Reverse the above procedure.