Janome Memory Craft 500E - Monogramming Function Keys

22
!0
Function Keys
q Font selection key
Press this key to open the font selection window.
w Lettering orientation key
Press this key to select the horizontal or vertical
orientation.
e Letter size key
You can select the following 3 letter sizes by pressing this
key.
The approximate letter sizes of upper case are as follows:
L (Large): 30 mm (1.2˝)
M (Medium): 20 mm (0.8˝)
S (Small): 10 mm (0.4˝)
r Letter case key
Pressing this key changes the letter case from upper
case to lower case and vice versa.
t Save le key
Pressing this key opens the save le window and allows
you to save the text or monogram as a le (refer to page
55).
y OK key
Press this key to conrm your entry and open the Ready
to Sew screen or the previous editing window.
u X key
Press this key to exit the monogram entry.
i Cursor key
Press these keys to move the cursor to the left or right.
o Delete key
Press this key to delete the character above the cursor or
the character in front of the cursor.
!0 Space adjust key
This key is activated only when a space is entered.
If the spaces between characters look uneven, insert a
blank space between characters and adjust the space
width to justify.
Press this key to open the space adjustment window.
To increase the space width, press the “+” key.
To decrease the space width, press the “–” key.
NOTE:
The space width is shown only in millimeters.
q
w
e r
y
t
i
i
u
o