INSTALLATION INSTRUCTIONS
This feature allows for the logic
controller to adjust for small operational
imbalances and permit the door to
operate as required in both directions
in conjunction with the electronic
sensitivity setting
Adjustments shall be made once the
electronic sensitivity setting has been
confirmed — refer to instructions under
the heading —”Setting the sensitivity
adjustment” . (previous page) step 8
Fine tuning is performed by careful
rotation of the corresponding – open or
close setting - as required.
To increase + the sensitivity of the
operator - rotate the required (open or
close) setting ANTICLOCKWISE
To decrease - the sensitivity of the
operator – rotate the required (open or
close) setting CLOCKWISE
STEP 9.
“Adusting the sensitivity”
To Next Page
Loading...