How to prevent electrode sticking with my Jasic Welding System?
If the electrode is sticking during welding with your Jasic Welding System, it could be because the arc force current is too low. Increase the arc force current appropriately.
What to do if there is no output current when pushing the torch trigger on my Jasic Welding System?
If the torch trigger is pushed, wire feeder works and gas flows, but there is no output current on your Jasic Welding System, and the protection LED is off, it could be due to: * The earth cable not being well connected to the workpiece. Reconnect it. * The control cable of the wire feeder not being well connected. Reconnect it. * The wire feeder or welding torch failing. Repair the wire feeder or welding torch.
Why is the fan not working on my Jasic MIG 400P?
If your Jasic Welding System's fan isn't working correctly, it could be due to: * A loose 3-phase power cord. Reconnect the cord. * A phase failure. Address the phase failure. * Overly low mains voltage. Welding can continue once the voltage recovers.
Why is the welding current unstable on my Jasic MIG 400P Welding System?
If you're experiencing unstable welding current with your Jasic Welding System, consider the following: 1. Ensure the pressure arm on the wire feeder is properly adjusted. 2. Verify that the drive roll matches the welding wire you are using. 3. Check the contact tip of the welding torch for wear and replace if necessary. 4. Inspect the guide tube in the torch and replace if worn. 5. Ensure you are using good quality welding wire.
What does error “Err 003” mean on my Jasic MIG 400P Welding System?
If your Jasic Welding System displays “Err 003”, there might be an issue with the air/water cooling switch position or a failure in the water circuit. Ensure the air cooling/water cooling switch is in the correct position. If it's a water circuit issue, resolve the water circuit failure.
What does it mean when my Jasic MIG 400P displays “Err 000”?
If your Jasic Welding System displays “Err 000”, it indicates an overcurrent or damage to power components. Try restarting the machine. If the problem persists, contact the service center.
What to do if my Jasic Welding System displays “Err 002”?
If your Jasic Welding System shows “Err 002”, it indicates overheating protection has been activated. Allow the machine to cool down, and it should recover automatically.
General| Wire Diameter | 0.8-1.2 mm |
|---|---|
| Insulation Class | F |
| Efficiency | 85% |
| Power Factor | 0.93 |
| Duty Cycle | 60% @ 400 A |
| Protection Class | IP21 |
| Input Voltage | 3 x 400 V ± 15% |
Ensures operators are trained and follow general safety guidelines for machine use.
Details on preventing electric shock, fire risks, and explosion prevention during operation.
Highlights hazards from welding fumes, gases, arc radiation, and noise.
Warns about burns from hot workpieces, moving parts, and magnetic field effects on pacemakers.
Covers lifting, connections, environment, duty cycle, and operational warnings.
Addresses common issues like no display, fan problems, and voltage errors.
Covers problems encountered during MMA welding, such as ignition and arc stability.
Details troubleshooting for MIG/MAG operations, including wire feeder and output problems.
To Next Page
