Jastram ENGINEERING DSC 100 - Page 9

DSC - General
Page 9 of 80
Commissioning
The Digital Steering Control system can be commissioned in either of two
ways, using a PC or laptop running Jastram’s DSC Setup Software or
through the keypad and display screen on the front of the DSC enclosure.
Prior to commissioning, ensure that steering gear and hydraulic system
are properly commissioned and in normal operating condition. Have the
technical data of the steering gear handy such as the hard over angles,
rudder speed, directional valve type and solenoid specifications.
For information regarding commissioning using the DSC Setup Software
see section 4.1
.
For information regarding commissioning using the keypad and display
screen see section 4.2
.
Doc No.: MAN01504, 20-02-06 DSC 100 & MCP 100 Manual