Jastram ENGINEERING DSC 100 - Configuration and Calibration; Dsc Setup Software

CONFIGURATION AND CALIBRATION – DSC Setup Software
Page 53 of 80
4 CONFIGURATION AND CALIBRATION
4.1 DSC SETUP SOFTWARE
Software Installation
1. Start the computer.
2. Insert Jastram’s Digital Steering Controller Software CD into your
computer.
3. From the Taskbar START button, choose the RUN… command, type:
D:\setup
and press the ENTER key.
The installer program will prompt for the information it needs.
Unless absolutely necessary, use the default choices fro installation
parameters such as the destination directory for the installed files.
4. Copy files ‘setupnew.dsx’ and ‘setupopn.dsx’ from CD into directory
C:\program files\DVCsetup
Getting Started
To start the program, click the START button from the Taskbar. From the
Start menu choose ALL PROGRAMS. From the Program list choose DSC
SETUP then click on the DSC Setup program icon.
After a few seconds a window called DSCsetup appears.
DSCsetup follows the conventions
of a typical Windows application.
The window called DSCsetup is the
application framework which
contains the DSC menu bar and up
to 2 Setup Windows labeled A and
B.
Each Setup Window contains the
complete configuration and
parameter data of a Digital Steering
Controller.
The data are contained in folders
and Property Sheets arranged in
an outline format.
Folders can contain other Folders and Property Sheets.
Doc No.: MAN01504, 20-02-06 DSC 100 & MCP 100 Manual