á Windows® NT™4.0 Driver
Installation
Upgrade video adapter to an existing system.
(Windows has been pre-loaded)
To proceeding the video display driver installation, you
may process the setup of service pack 6 or above
versions (Microsoft® Windows NT 4.0) first.
1. SELECT
the “Display” icon from control panel and then
Tab on the “Settings” screen.
2.
SELECT “Display Type...” button in the “Settings”
screen.
3.
SELECT “Change...” button from the Adapter type
section.
4. SELECT
“Have Disk...” button from the Change Display
screen.
5. Microsoft Windows NT 4.0 will prompt you for the
correct path where the video drivers are located. ENTER
D:\MX\Winnt4, where D: is the letter of your CD ROM
drive that the Software & Documents CD has been
inserted.
6. If the driver “3DForce2 MX Series, nVIDIA GeForce2
MX 200/400” is listed under the Display list,
SELECT
the OK” button to continue.
7. Once the driver files are copied.
8. Close all display screens to restart the computer.
InstallShield® Program:
The procedure of display driver installation it required setup
with service pack 6 (Microsoft® Windows NT™4.0) first. After
your windows desktop fully loaded with service pack 6, you
may insert the software CD into CD ROM drive and following
the install steps below:
25
To Next Page
Loading...