www.procontechnology.com.au Phone: (03) 98306288
SAFETY WARNINGS
The following safety information must be observed to insure
maximum personal safety during the operation at this meter:
♦ Measurements beyond the maximum selected
range must not be attempted.
♦ Extreme care must be taken when measuring above
30 VAC or 60VDC, especially on live bus-bars.
♦ To measure voltage, the instrument must not be
switched to a current or resistance range, or to the
diode check or buzzer position.
♦ Circuits must be de-energised and isolated before
carrying out resistance tests.
♦ The rotary function switch must only be turned after
removing test connections.
♦ All external voltages must be disconnected from
the instrument before removing the battery.
♦ Test leads and probes must be in good order, clean,
and with no broken or cracked insulation.
♦
UK Safety Authorities recommend the use of fused
test leads when measuring high energy systems.
♦ Replacement fuses must be of the correct type
and rating.
♦ The instrument must not be used if any part of it is
damaged.
To Next Page
Loading...