www.procontechnology.com.au Phone: (03) 98306288
DC Direct Current or Voltage
V Volts
A, mA,
µ
A Amps, milli-Amps, micro-Amps
OPERATION
To turn on the meter rotate the function switch from the
OFF position to any measurement position.
For best battery life, ALWAYS turn the function switch to
the OFF position when the meter is not in use. This
meter has an Auto OFF capability that automatically
shuts the meter OFF after 30 minutes.
NOTE: On some low AC and DC voltage ranges, with
the test leads not connected, the display may show a
random, changing reading. This is normal and is caused
by the high-input impedance and the input sensitivity.
The reading will stabilize when connected to a circuit.
MODE button
Selects AC or DC measurement when in Voltage or
Current modes, also selects resistance, diode, continuity
or capacitance modes and °C or °F display modes.
To Next Page
Loading...