www.procontechnology.com.au Phone: (03) 98306288
two central screws using a Phillips head screwdriver.
3) Remove the pull-out stand and remove the six screws
using a good-quality Phillips head screwdriver. Be
careful not to lose the screws, washers and rubber
seals.
4) Remove the back of the meter with care.
5) Remove the old fuse from its holder by gently pulling it
out. If necessary, use a screwdriver as a lever.
6) Install the new fuse into the holder.
7) Always use a fuse of the proper size and value.
(0.5A/1000V fast blow for the 400mA range [SIBA
70-172-40], 10A/1000V fast blow for the 10A range
[SIBA 50-199-06]).
8) Replace and secure the rear cover, battery and
battery cover.
WARNING:
To avoid electric shock, do not operate the
meter until the rear cover and battery cover are in
place and fastened securely.
To Previous Page
Loading...