5-1
The slideout room system is designed for additional floor space and comfort. The
mechanical components are gear driven. Electric powered slideout room systems
have a manual override to allow you to extend or retract the slideout room(s) in
case of a power loss. Make sure you have sufficient power available before
operating your slideout system.
OPERATING THE SLIDEOUT
1. The auxiliary battery (customer supplied) must be fully charged and
connected. If possible, the RV should be hooked up to 120-volt AC power so
the converter operates.
2. The RV must be level and the stabilizer jacks in the extended position.
3. Locate the slideout room control switch. The main slideout switch is located
in the command center. The bedroom slideout switch may be located in the
command center or on a bedroom interior wall depending on the model.
4. To move the room out, press the OUT section of the switch and hold it until
the motor stops (travel time is approx. 25 seconds). Operating the switch after
the room is fully extended will damage the switch and motor.
WARNING
Ensure that the motorhome is level before operating the slideout room. Water
leaks and other problems could result i
when it is moving. Keep away from the slide rails when the room is in motion.
The gear assembly may pinch or catch on loose clothing causing personal
injury.
Additional support jacks are not needed under the slideout. Damage can
occur to your slideout room from improper use of aftermarket support jacks.
To Next Page
Loading...
Need help?
General
