8-9
THIS VALVE IS A SAFETY COMPONENT AND MUST NOT BE REMOVED FOR
ANY REASON OTHER THAN REPLACEMENT.
WHEN REPLACING THE PRESSURE–TEMPERATURE RELIEF VALVE
DO NOT install anything less than a combination pressure–temperature relief
valve certified by a recognized testing laboratory that conducts periodic
inspections of such products and certifies them as meeting the requirements
for Relief Valves and Automatic Gas Shutoff Devices for Hot Water Supply
Systems, ANSI Z21.22. Valve must have a maximum set pressure not to
exceed 150 psi.
Install valve into opening provided and marked for this purpose on water
heater.
Installation must conform with local codes or in the absence of local codes,
American National Standard for Recreational Vehicles, ANSI A119.2/NFPA
501C.
For more information
Refer to the manufacturer’s user guide included in your Warranty Packet.
Maintenance
Inspect your water heater monthly and have it serviced at least once a year by the
manufacturer’s recommended service technician. Refer to the manufacturer’s
owner’s manual for detailed inspection and maintenance information. If you have
further questions contact your RV dealer, the manufacturer, or Jayco Customer
Service
.
OUTSIDE SHOWER
A handheld shower assembly with both hot and cold water is available for washing
or rinsing with the outside shower.
1. Be sure the water heater is ON and had sufficient time to heat the water.
2. Open the outside shower compartment door.
3. If dry camping, be sure the 12-volt water pump is ON.
4. Remove the handheld shower from its holder.
5. Turn ON the hot and cold faucet knobs, and adjust the water temperature as
desired.
6. To activate the handheld shower turn ON the sprayer head attachment (some
models).
To cease operation, close the faucet knobs. After the water has been allowed to
drain from the shower head, replace it in the outside shower compartment. Any
remaining water in the shower hose will drip or run out; this is not a leak but
performs as intended.
FAUCETS
To Next Page
Loading...
Need help?
General
