5-2
After the slideout is extended, verify
that the corners of the black rubber
seal are set up correctly. The corners
of this seal are cut at a 45° angle.
The top of the seal must overlap the
side of the seal to avoid the
possibility of water penetration.
Retracting slideout room
Press the IN section of the slideout control switch and hold it until the motor stops.
Operating the switch after the room is fully retracted will damage the switch and
motor.
Maintenance
Your slideout system has been designed to require very little maintenance. To
ensure a long life of your slideout system, read, understand and follow these
simple instructions. This system contains a pre-lubed bearing that is lubricated
when the room is moved in and out. Do not spray oil or grease on the rails while
the room is extended.
TROUBLESHOOTING THE SLIDEOUT
If the slideout does not move when the slideout switch is depressed, follow these
steps.
Check the auxiliary battery (customer supplied) for a full charge and good
wire connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.
If the slideout is extended, refer to the following section on overriding the
specific slideout system installed on your RV.
If the slideout is retracted, leave it in that position.
Contact your dealer or Jayco Customer Service for repair assistance.
If the slideout extends crooked or only one side moves, follow these steps.
Follow steps on overriding the specific slideout system installed on your RV.
You may need to push the side that is not sliding to get it to retract all the
way.
Contact your dealer or Jayco Customer Service for repair assistance.
To Next Page
Loading...
Need help?
General
