placed on a charger until it is fully charged. It may be possible to “jump” the RV battery
temporarily to extend or retract the room. Consult Customer Service before attempting to
“jump” the auxiliary battery.
Only 1 Side Moving:
The Schwintek Inwall Room Slide has a separate motor to operate each side of the room.
Does only 1 side of the room move a short distance (2 to 4 inches) and stop?
Will Non-moving side move with help?
If only 1 side of the room is moving, then with another person’s assistance press the switch
to extend or retract the room while pushing the non-moving side in the appropriate
direction. On larger rooms it may be necessary to have 2 or more people pushing the
room.
Non-moving side moved manually:
Try to push the non-moving side in and out. If a motorshaft has broken then it will be
possible to move that side of the room several inches by hand. Larger rooms may require
several people to push.
Debris in the rack:
Check all 4 gear racks on the side of the room for debris.
Do the status LEDs light?
Locate the slide controller for the slideout in question (explained previously). When the
room slideout direction switch is actuated, do the status LEDs light up. Check this in both
the extend and retract modes.
Refer to the Schwintek Slide Room Operation Guide included in your owner’s packet for
further information. Call Lippert at (866) 524 – 7821 or visit the Lippert website for more
troubleshooting information http://www.lci1.com
5-6
To Next Page
Loading...
