Jayco Eagle - Installing LP Containers

43
1. Knob to open valve to fill or to use camper.
2. Complete valve assembly.
3. “10%” valve, small brass knob or slot screw.
4. Container mounting stand.
A warning label has been located near the LP gas container. This label reads:
THIS GAS PIPING SYSTEM IS DESIGNED FOR USE OF
LIQUEFIED PETROLEUM GAS ONLY. DO NOT CONNECT
NATURAL GAS TO THIS SYSTEM. DO NOT FILL
CONTAINER(S) TO MORE THAN 80 PERCENT OF CAPACITY.
Securely cap inlet(s) when not connected for use. After turning
on gas, except after normal container replacement, test gas
piping and connections to appliances for leakage with soapy
water or bubble solution. Do not use products that contain
ammonia or chlorine. AD-34
Installing LP Containers
1. Place container onto steel angle rack.
2. Insert 2-
1
/
4
" x
1
/
2
" bolts through hole in
center of angle.
3. Attach lock washer and nut onto bolt.
CAUTION: Ensure that all fasteners are secured before traveling.