MAINTENANCE CHECKLIST
Prior to First Trip
q Install privacy drapes. (Privacy drape option only)
q Condition the tent.
q Grease zerks in master tubes.
q Check LP gas lines for leaks.
q Test LP gas detector.
q Sanitize fresh water system.
q Tighten wheel nuts to specified torque values.
q Open all windows and the door and start the furnace. Leave the windows and
door open and the furnace on until all fumes fully dissipate. (Furnace option
only)
First Ten Miles (Fifteen Kilometers)
q Tighten wheel nuts to specified torque values.
First Twenty-Five Miles (Forty Kilometers)
q Tighten wheel nuts to specified torque values.
First Fifty Miles (One Hundred Kilometers)
q Tighten wheel nuts to specified torque values.
First Two-Hundred Miles (Three Hundred Twenty-Two Kilometers)
q Tighten wheel nuts to specified torque values.
q Have brakes adjusted by a qualified service technician.
Each Trip
q Test LP gas detector.
q Inspect bed bow supports.
q Check battery water level. (If equipped with battery)
q Check tire pressure and wear.
q Check running lights.
q Inspect safety chains for signs of wear.
q Test brakes.
After Every Tire Change
q Tighten wheel nuts to specified torque values at ten miles, twenty-five miles
and fifty miles (15, 40 and 100 kilometers).
Daily
q Recharge battery after each use. (If equipped with battery)
q Ensure LP gas detector operation light is green.
69
To Next Page
Loading...
