Jayco SENECA 2023 - Leveling System Operation

34

Campsite Hook-Up
 Refer to Electrical Systems section before connecting the shore line power cord
(when using full hook-up) OR before starting the generator or operating the ve-
hicle on 12-volt power when dry camping.
 Refer to Fuel & Propane System section before using the LP system. Open the LP
gas tank valve (if so equipped) slowly. There may be air in the lines and ve to
thirty seconds of time is needed to bleed air before LP vapor lls the lines.
 Refer to Plumbing Systems section before connecting the fresh water supply or
turning ON the water pump or water heater.
 When using full hook-up, connect the sewer hose to the campsite sewer hook-up.
 If applicable, start the refrigerator and the cooling or heating system.
 


Leveling System
       
       

 The leveling system is designed only for leveling the unit and should
never be used to provide service for any reason under the motor home
such as changing tires or servicing the system. It is not recommended
that you change a tire yourself.
 Check that potential jack contact locations are clear of obstructions or
depressions.
 Keep people clear of the motor home prior to turning the leveling system
on and while the leveling system is in operation.
 Never expose hands or other parts of the body near hydraulic leaks. High-
pressure oil leaks may cut and penetrate the skin causing serious injury.
 After starting the leveling cycle, it is important that occupants do not
move around in the motor home until the vehicle is level. Failure to re-
main still during the leveling cycle can aect the leveling jack system
sensors.
 Never lift the wheels o of the ground when leveling the motor home.
 Do not move the motor home while the jacks are still in contact with the
ground or extended. Damage to the vehicle could occur.
 Do not rely solely upon warning lights to determine the position of the
leveling jacks. It is the operator’s responsibility to check that all the lev-
eling jacks are fully raised in the travel mode before moving the motor
home.

 

  When
backing up, proceed cautiously and be prepared to stop.

