EasyManuals Logo

Jayco SENECA 2023 User Manual

Jayco SENECA 2023
141 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
83

Draining The Fresh Water System
Water tanks may be drained through a valve located near the tank. A recreational vehicle
with a demand pressure pump system will have low-point drains attached to the water lines
(normally located near the water tank).
These low-point drains will release water in the supply lines by opening the valves and all
faucets. The water heater has its own drain plug. To drain the permanent fresh water holding
tank and supply lines:
1. Turn the water heater power OFF (turn o the electric and LP gas
switches).
2. Open all faucets, including the outside shower faucet (if so equipped).
3. Open the “fresh tank drain” valve. Methods to drain the fresh water
tank may vary by model. Fresh water tanks can be drained by one of
the following methods:
A white plastic drain attached to the exterior wall
A valve located inside the RV adjacent to the water tank (turn 45° to open or
close).
Pull the white “T” handle on the fresh water holding tank to drain the water



. When not in use, the water lter cartridge should
be stored out of freezing temperatures. RV antifreeze will damage the water lter cartridge.
Filter locations will vary by model. They are typically located in a compartment behind the
utility center (if so equipped).

1. Turn o water supply using two valves located on the water lines on each
side of the canister. Water pump should be OFF.
2. Place drip pan below lter housing to catch any spillage.
3. Press the red button on top of the lter housing to release pressure.
4. Using a spanner wrench, rotate the lter housing. Unscrew the housing
completely, dump water out and remove the lter (dispose of the old lter
properly).
5. Clean the inside of the lter housing with mild detergent. Thoroughly rinse
and wipe clean.
6. Remove the O-ring from the groove in the housing and wipe clean. Coat with petro-
leum jelly.
7. Replace the O-ring in the groove, making sure it is properly seated.
8. Install the new lter cartridge.
9. Replace the canister housing (hand tighten is normally sucient).
10. Turn on the water supply, turn the pump ON, open a faucet and check for leaks. Turn
the pump OFF afterwards.
no bypass
must
Each new recreational vehicle is winterized with RV antifreeze before it is shipped to the
dealer. To use the water purication system, full system canister water lines need to be
ushed of antifreeze and then the lter installed in the canister before use.
Refer to the manufacturers owners manual and the label on the water lter cartridge for
further information.


Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jayco SENECA 2023 and is the answer not in the manual?

Jayco SENECA 2023 Specifications

General IconGeneral
ChassisFreightliner S2RV
Horsepower360 hp
Torque800 lb-ft
Fresh Water Capacity72 gallons
ManufacturerJayco
Year2023
CategoryMotorhomes
ModelSENECA
Gross Vehicle Weight Rating (GVWR)26, 000 lbs
Engine6.7L
Width102 inches
Height12 feet 6 inches
Transmission6-speed automatic

Related product manuals