87
1. Turn water heater power OFF (both electric and LP gas on standard storage water
heater). Single switch is inside the RV for the tankless water heater.
2. Level the recreational vehicle and drain the fresh water system. (see Draining the Fresh
Water System).
3. Close the low point drain valves and the fresh water tank drain valve.
4. Water lter preparation:
Remove the canister, take
the lter out of the canister, then reattach the empty canister.
Use the clear plastic tube
(supplied with RV) to bypass the water lter.
5. Connect a garden hose to the city water inlet (do not use your fresh water hose to sani-
tize the water lines or the tank).
6. Set the colored coded valves to the SANITIZE setting:
The water heater is automatically bypassed on this setting.
7. Place the other end of the hose in a container holding sanitizing solution.
8. Turn the pump switch ON (red LED will light). The solution will be drawn into the
fresh water tank. Turn the pump OFF when solution has been drawn into the tank. To
aid in siphoning, set the container on a surface approximately (2) feet o the ground.
The drain valves must be turned OFF.
9. Remove the chlorine container and nish lling the fresh water tank with clean (po-
table) water until the tank is full. Keep the valves set on SANITIZE.
10. Fill the fresh water tank full of clean (potable) water. Use water either from a pressur-
ized source, or from a container. Tank level can be viewed on the monitor panel inside
the RV.
Set the valves to
the POWER FILL TANK setting. Connect a non-
toxic drinking hose to the city water ll inlet. Con-
nect the other end of the hose to the pressurized water
source. Turn on the water source and ll until is full
(). Disconnect the hose from the wa-
ter source rst, then disconnect from the utility panel.
Set the
valves to the SANITIZE setting. Insert a hose into
the city water ll inlet, place other end of the hose in
a container of water. Turn pump ON to draw water
into the tank until tank (). Remove
the hose and the container. To aid in siphoning place
the container approximately (2) feet o the ground.
The drain valves must be closed.
11. Leave the hose attached to the city water connection inlet and place other end of hose
in a container of fresh water. Turn the pump ON. Fresh water will be siphoned into
the tank. Turn pump OFF when tank is full. Disconnect the hose from utility center.
To Next Page
Loading...
