59
3. Place the end of the sewer hose into the approved dump station.
4. Open the tank dump valve Close the dump valve when the hold-
ing tank is empty.
5. Open the grey tank dump valve (lose the dump valve when the
grey holding tank is empty.
6. Remove, clean and store the sewer hose.
7. Close the hose housing dust cap.
You can locate dump stations throughout the United States and
Canada in Woodall’s, Rand McNally Camp Guide, Good Sam Camp
Guide, KOA Kampgrounds Camp Guide and various other publications. Some fuel stations
also have dump stations. Please contact your RV dealer for assistance in the purchase and
installation of a sewer hose or sewer hose extension (if needed).
No special preparation is required, however, placing a small quantity of chemicals into this
tank, such as baking soda or an approved RV chemical, will reduce odors from food particles
in the system.
Cassette Toilet
The toilet is made up of two parts: a permanently xed toilet and a waste tank that is ac-
cessible from the outside. The removable waste tank is located under the toilet and can be
removed via an access door on the outside of the motor home.
1. Remove the waste tank by pulling the safety catch upwards.
2. Pull the waste tank outwards to the stop. Tip it slightly and take out the tank completely.
3. Place the tank upright and turn the emptying spout upwards.
4. Remove the cap, with the measuring cup inside, from the emptying spout and pour the
stated quantity of toilet treatment into the waste tank. This helps breaks down waste,
avoids unpleasant smells in the waste tank and keeps the inside of the waste tank clean.
5. Add approximately ½ gallon (2 liters) of water - enough to ensure that the bottom of the
waste tank is covered. Screw the measuring cap back onto the emptying spout. Turn the
emptying spout back to its original position.
6. Slide the waste tank back into its original position via the access door.
7. Make sure that the waste tank is secured with the safety catch. Shut the access door
and lock it.
8. Turn the toilet bowl to the desired position.
9. Run some water into the bowl by pressing the ush button once. The toilet may be used
with the blade open or closed. To open the valve, pull the valve handle under the toilet
bowl towards you. The toilet is now ready for use.
Never add toilet uid via the valve blade or via the toilet.
To Next Page
Loading...
