69
The nish is durable and resistant to most household spills. However, spills should be
wiped up promptly to avoid potential problems. Excessive prolonged exposure to direct
sunlight, high temperatures and high humidity can cause damage to both the nish and the
wood itself.
To clean, use a mild solution of soap and lukewarm water with a soft sponge or cloth. Wipe
dry with a soft, clean cloth.
Putty sticks can be used to cover scratches on the wood surface wall panels. These can be
obtained from local hardwood stores and lumberyards. Contact your dealership service de-
partment for assistance in repairing décor paneling.
Dust and wipe clean with soft, damp cloth or chamois, wiping gently. Do not use gritty or
abrasive particle soaps or scouring compound to clean ABS plastic. Avoid using “citrus” or
biodegradable cleaners that contain “D-Limonene” as they may damage plastic materials.
Flooring
Periodically vacuum or sweep to remove dirt and gritty particles. Although most common
spills will not permanently stain the vinyl oors, they are usually easier to remove if wiped
up before they set. Blot with a paper towel and wipe clean with a damp cloth. Do not use
dish detergents or vinegar and water because they will dull your oor.
To care for the vinyl oor covering, use a damp mop with water and a mild cleaner on the
entire oor. DO NOT SOAK THE FLOORING. Use care to avoid wetting the carpet edges.
To avoid problems of “yellowing” linoleum, the ooring manufacturer recommends avoid-
ing cleaners that contain oil based solvents (i.e. lemon oil, Murphy’s Oil Soap, etc.).
Flooring Top Seal
The linoleum oor is equipped with a factory-applied urethane nish. No additional nishes
are required, and applying any additional nishes is not recommended. For detailed care
and maintenance information, refer to the manufacturer’s user guide.
Remove all gross soiling (food, gum, residues, etc.). Take care if using a scraper or
putty knife to avoid permanently damaging the surface of the ooring.
Clean the ooring using a microber dust mop. If necessary, vacuum the oor to
rst pick up any large particles.
Apply a properly diluted neutral cleaner to the surface using a microber wet mop
pad.
If necessary, use clean water and a clean microber mop pad to remove any re-
maining residue.
Remove all gross soiling (food, gum, residues, etc.). Take care if using a scraper or
putty knife to avoid permanently damaging the surface of the ooring.
Clean the ooring using a microber dust mop. If necessary, vacuum the oor to
rst pick up any large particles.
Do not use abrasive cleaners as they may cause the vinyl to scratch and be-
come dull. Do not use cleaners that contain bleach.
To Next Page