71
Power Bunk Bed
Your motor home may be equipped with a power bunk bed.
To operate the bed, turn the key switch to the on position.
Press the UP or DOWN arrow button. A green LED light
will light up indicating the bed direction. The bed will con-
tinue to move until
The switch is released.
A pre-set stop position is reached.
The bed is being lifted and the end-of-stroke posi-
tion is reached.
When upper bunk is positioned where you want it, turn the key to the OFF position.
You should adhere to the following safety information:
Safety devices shall not be tampered with for any reason.
Before starting the vehicle engine and driving, always make sure the bed lifting
system is in its highest position and the safety belts are fastened.
The bed lifting system shall only be used by adult and responsible sta.
It is forbidden to use the bed lifting system while the vehicle is running.
It is forbidden to start the bed lift system manually with disconnected wires from
motor unit to control unit.
Should the mechanism not work, do not use the bed and ask for assistance at the
next service center.
There should be no people, pets or objects on or below the bed while rais-
ing or lowering it; the area should be clear when operating.
Never ride on the bunk while the vehicle is in motion.
Children should always be supervised when entering or exiting the bed.
Do not stand in the bed lifting system operation area.
Do not reach into the bed lifting system components while being oper-
ated.
Do not interfere with the bed lifting system while operated, neither with
any objects nor with hands.
The bed lifting system must never be used while the vehicle is running.
Always comply with the bed lifting system maximum load capacity, 725
lbs. (328 kg) in static conditions.
Never lift weights that overcome the bed lifting system maximum load,
i.e. 132 lbs. (59 kg) in dynamic conditions, people or animals are not
included and they must not be on the bed when the system is operating.
To Next Page
Loading...
