Jazz DV150 Wiring and IR Mod.
1) Remove batteries from the camera
2) Remove the 6 screws which hold the case together. The two screws on the bottom of the
camera are located under the serial number label.
3) Open the battery door. GENTLY pry open the case from the bottom. Then push the front of
the case upward to dislodge the plastic case catches on the top of the camera
4) Now that the front of the case is removed, disconnect the microphone from the front of the
case. Simply pull up on the rubber grommet to remove it from the mount hole. Remove the
screw which holds the record led in place and remove the led from under the holder
To Next Page
Need help?
General
