SWITCHING TO RADIO MODE
Press MOD button (5) shortly to select radio mode,
the radio mode appears in the display together with
the memory band and frequency.
SELECTING THE FREQUENCY BAND
At radio mode, press BND button (4) shortly to se-
lect the desired band.
The reception band will change in the following or-
der:
FM1 FM2 FM3 AM1(MW)
AM1(MW)
SELECTING STATION
Press the / button (1) shortly to activate auto-
matic seek function. Press for several seconds until
“MANUAL” appears on the display, the manual
tuning mode is now selected. If both buttons have
not been pressed for several seconds, it will return
to seek tuning mode and “AUTO” appears on the
display.
AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic memory storing
Long press AMS button(20) for several seconds,the radio
searches from the current frequency and checks the sig-
nal strength until one cycle search is finished. And then 6
strongest stations are stored into the corresponding preset
number button.
- Program scanning
Short press AMS button(20) to scan preset station. When
the field strength level is more than the threshold level of
stop level,the radio is holding at that preset number for
several seconds with release mute ,then searches again.
STATION STORING
Press any one of the preset buttons (8~13) to se-
lect a station, which had been stored in the memory.
Press this button for several seconds (until 2’nd
beeps come out), now the current station is stored
into the number button.
LOCAL/DISTANT
Press REMOTE Controller LOC button to select
between local and distant stations. Local setting for
reception of strong station, and a distant setting for
reception of weaker stations.
MONO/STEREO
Press REMOTE Controller ST button to select
mono or stereo mode. You can sometimes improve
reception of distant stations by selecting mono op-
eration.
ENGLISH
10 EN
RADIO
To Next Page
Loading...